Helical Tiebacks

helical tiebacksStraighten & Strengthen with Helical Wall Tiebacks

Helical tiebacks are foundation lifting devices designed to straighten or strengthen basement and retaining walls. This method of shoring has become very popular with the engineering community, due to their strength and ease of measuring capacity. A helical wall tieback has many of the same benefits as other helical anchors in the fact that they install with lightweight, portable equipment, are not adversely affected by weather and can be load tested immediately upon installation.

Tiebacks are horizontally-aligned structural elements that provide lateral reinforcement to retaining walls. These technologies apply to projects ranging from small basement walls to large commercial projects including bulkheads or temporary and permanent earth support.

Bowing walls: Tiebacks are required to repair a wall once it has bowed over three inches. In many cases, the tiebacks are installed from inside the basement using hand-held equipment. Earth

Earth Support: Tiebacks are pre-engineered systems that can resist large forces immediately. Helical tiebacks can easily hold loads of up to 150 kips (kilopounds).

Features & Benefits of Helical Tiebacks

Features

  • Predictable results
  • Cost-effective method
  • Easy to store, reusable
  • Pre-engineered system
  • Labor-saving keeps the crew small
  • Screws into place (not pre-drilled)
  • Site-specific to conditions and loads
  • Terminations for various thread bars
  • Less equipment than grouted tendons
  • A bearing device, not friction dependent
  • Extendable with a bolted joint connection

Benefits

  • Installs in any weather
  • Installs in limited access areas
  • No excavation or spoils to remove
  • Permanent or temporary (removable)
  • Labor-saving – as few as four on a crew
  • Capacity proportional to installing torque
  • No concrete trucks or grout pumps needed
  • Install with equipment for grouted tendons

At Tar Heel Foundation Solutions we can utilize helical tiebacks to support your cracked, bowed or leaning foundation and retaining walls.

How Does a Helical Wall Tieback Work?

First, a small hole is cored through your foundation or retaining wall. Galvanized steel helical anchor sections are hydraulically screwed out through your foundation or retaining wall into the soil while torque is monitored to achieve capacity. The amount of torque produced by the helical anchor correlates to the load the helical anchor can carry. Once appropriate distances and capacities are reached, a wall plate is then secured to the foundation or retaining wall. Once all components are connected and tightened, your foundation or retaining wall is permanently stabilized.

Contact us today and we can advise you on the best method of repair for your foundation problem.

Get A Quote




    25 + = 27

    Earth Contact Products - Foundation Repair Products

    Preferred Installer of Earth Contact Products

    ECP is "The Very Best" manufacturer of steel foundation repair, waterproofing & anchoring products in the industry.

    Call Now